The owner knows that the electromagnetic flowmeter can give full play to its performance under the condition of full pipe. In case of harsh site, it can not reach full pipe, which will have a great impact on the electromagnetic flowmeter. So how to solve this problem? actually
This is not a big problem, as long as you follow certain methods and steps to operate.
1. The pipes should be checked for blockage. If the pipe is blocked, try flushing it with water first. If this does not solve the problem, it may be necessary to use high-pressure water flushing or other methods to clean the pipeline.
2. If the pipe is not blocked, consider whether there is leakage. If there is leakage, the flowmeter can only work normally before the leakage is repaired. In addition, if a serious leak is found, the flowmeter may need to be completely replaced.
3. When the pipe of the electromagnetic flowmeter is not enough, carefully check whether there is blockage or leakage. It is enough to adopt corresponding treatment methods according to the actual situation.
It is a common problem that the electromagnetic flowmeter pipe is not full, which can be usually solved through maintenance.
1. Check the electromagnetic flowmeter for water leakage or leakage, and repair it in time if any.
2. Check whether there is water or debris on the surface of the electromagnetic flowmeter, and if there is, clean it in time.
3. If there is corrosion or rust on the surface of the electromagnetic flowmeter, a small amount of strengthening agent can be used for maintenance.
In fact, this is not a big problem. We can solve this problem by adding a protective sleeve to the electromagnetic flowmeter. The function of the protective sleeve is to protect the measuring part of the electromagnetic flowmeter when it cannot be completely covered. By increasing protection
We can effectively avoid the interference of water to the electromagnetic flowmeter, thus ensuring its accuracy.
If the electromagnetic flowmeter pipe is not full, measurement error or calculation error may be caused. Therefore, before using the electromagnetic flowmeter, it must be ensured that the pipeline is completely full.
However, sometimes the pipe may not be completely full due to various reasons. At this time, it is necessary to correct the measurement data.
1. It should be judged whether the electromagnetic flowmeter is under standard operating conditions. If not, the data should be corrected through standards.
2. Normal measurement methods shall be used to supplement or replace the data of incomplete pipeline. For example, water level gauge can be used to supplement or replace the data of electromagnetic flowmeter.
3. Before any correction, the original data should be fully analyzed to accurately understand the problem and find a better solution.
How to Solve the Problem of Electromagnetic Flowmeter Pipe Not Full
You can try to use some special liquid to fill the electromagnetic flowmeter pipe, which can effectively avoid the electromagnetic field being affected. Secondly, you can try to use some special sensors to measure the electromagnetic field, so that you can get more accurate measurements.
Post time: 29-09-22