The magnetic flap level gauge is very cost-effective, so many people choose the magnetic flap level gauge in many working conditions of measuring the level gauge as long as it is suitable. Its principle is realized by the principle of the coupling and the magnetic coupling. of. It has a wide measuring range/clear display/simple structure/installation form can be side-mounted, top-mounted, etc., suitable for various working conditions of low temperature/high temperature/vacuum, high pressure, and varying degrees of corrosion! Although our magnetic flap level gauge itself is a product that does not require much maintenance, it may need to be maintained after a long time. Next, Huikeda will add to everyone the daily maintenance and maintenance methods of the magnetic flap level gauge, hoping to help the majority of instrument users!After the magnetic flap level gauge has been running for a long time, because the pontoon may absorb the dirt in the medium, after a long time accumulation of too much dirt will also affect the normal use of our magnetic flap level gauge , So it’s best to check and clean it from time to time a year. We must pay attention to the order when cleaning.1. First open the cap of the iron pipe of the magnetic flap level gauge, and then carefully pick up the magnetic flap level gauge, and clean the surrounding iron filings/dirt by the way.2. Before cleaning, put our magnetic flap level gauge in Xi’an neatly, put the pipes and lines into categories, and then take protective measures for removal. On the one hand, there is corrosive liquid in the magnetic flap level gauge. Cause harm to yourself.3. When the magnetic flap level gauge is cleaned, we can use trichloroethylene or ethanol to inject the liquid into a half of the height of the pressure hole, let it soak for about 5 to 10 minutes, and then Pick it up and shake it gently until it is cleaned. In this case, using a brush to brush may damage the pressure-sensitive diaphragm inside
4. After cleaning, put the level gauge back slowly, and then install it far away. After the installation is complete, confirm and correct the detection value of the gauge!
Post time: 21-09-21