The storage tanks commonly used in the textile industry are filled with chemical raw materials. These raw materials are transported to the storage tank. The liquid level of the storage tank can be displayed. At this time, it can be sent to use a non-high frequency radar level gauge. It is actually The liquid level can be displayed on-site. Since the appearance of this liquid level gauge, how many problems have been solved in the textile industry. The accuracy of the liquid level is related to the installation. How to install the high-frequency radar level gauge? The following section reveals some specifications for installing high frequency radar level gauges in the textile industry.
On-site installation instructions for high-frequency radar level gauges:1. Installation location:The distance to the tank wall is recommended to be 1:6≤1/4 of the diameter of the tank (at least 300 mm, at least 400 mm concrete tank)B. Don’t install it in the middle of the metal canC. Don’t put it in a blank portWhen choosing the length of the probe, pay attention to the distance between the bottom of the probe and the bottom of the tank about 30 mm, and pay attention to the temperature of the medium.2. Obstacles in the tank:When installing at least 200 mm, pay attention to the detection distance barrier.3. Eliminate interference:Interference echo suppression: The software can suppress interference echo to achieve ideal measurement results.The viscosity of the bypass pipe and the guide pipe (only for liquid) does not exceed 500 cm. Bypass pipes, waveguides or ducts can avoid interference.4. Liquid standard device:For 500 cst media with poor adhesion, a tubular probe is a better solution, and its characteristics are as follows:A. Excellent reliabilityB. It can be used in any medium with a dielectric constant greater than or equal to 1.4. The measurement has nothing to do with the conductivity of the medium.C. The measurement of the size of obstacles and short pipes in the fuel tank does not affect the measurement.D, higher than the lateral pressure that the rod probe can withstandE. For high-viscosity media, it is recommended to use a rod probe.5. Installation of horizontal and vertical tanks:A. Tube probes and rod probes can be up to 6 meters long, and 8 mm cable probes can be used to measure tanks with a distance of more than 6 meters.B. Measurement of the same installation and fixing method as the solid powder binC. As long as the probe can avoid contact with the tank wall, there is no limit to the distance from the tank wall.If there are more obstacles in the tank, or too close to the probe shaft, choose a tubular probe.6. Measurement of corrosive media:If the corrosive medium is measured, a plastic sleeve with a rod probe cover can be selected for measurement.
Post time: 21-09-21