Many netizens pointed out that some magnetic levitation level gauges are not accurate when used for a long time. This is mainly related to the usual method of use and cleaning frequency. The magnetic suspension level gauge must be cleaned and adjusted regularly in order to maintain the accuracy of the level gauge. The editor will explain the cleaning method of the magnetic levitation water level gauge.1. What is the cleaning method of the magnetic flap level gauge?1. After long-term use of the magnetic flap level gauge, since the measuring tube body will absorb the dirt in the medium, the magnetic flap level gauge should be cleaned once a year.2. The magnetic flap level gauge draws lines to make the pipeline and organization smooth and pleasant time and oil changes. Sometimes it will light up the phenomenon of fuel oil, hydraulic oil, normal, oil, oil, oil gun, oil cup, and oil required by open standards. Cleaning of linoleum, trichloroethylene and alcohol. Do not use the device to clean the through hole, so as to avoid the pressure of the damaged sensitive diaphragm becoming sensitive.3. When cleaning the magnetic flap level gauge, open the iron pipe of the level gauge, pay attention to the upper limit screw, and clean the waste, garbage, and surrounding dirt.Cleaning method of magnetic levitation water level gauge2. What are the precautions for the installation of the magnetic levitation water level gauge?1. Do not allow magnetic permeability materials to approach the periphery of the magnetic flap level gauge body, so that the metal wire fixation is invalid. Otherwise it will affect the normal operation of the magnetic flap level gauge;2. When users use heat tracing pipelines by themselves, they should choose non-magnetic permeability materials, such as copper tubes. The heating temperature is determined according to the condition of the medium;3. The installation of the magnetic flap level gauge must be vertical. Install a ball valve between the magnetic plate level gauge and the reed tube of the container for easy inspection and cleaning;4. There should be no solid impurities and magnetic substances in the medium to avoid hanging the float;5. Before use, use the correction magnet to turn the small balls below zero into red, and the other balls to white;6. Open the bottom flange and put in the magnetic float (note: the magnetic end of the heavy end faces upwards and cannot be turned over.);3. How to deal with common faults of magnetic levitation water level gauge?1. There is liquid in the container, but it is not displayed. The reason is that the density of the medium has changed; the float is broken; the connection part of the is blocked.Solution: Replace the float and unblock the connecting pipe.2. The false liquid level phenomenon often occurs for the following reasons. In the processing of the measuring medium, bubbles are generated by tiny impurities; the magnetic properties of the float and the magnetic reversal plate become weak; the dry yellow tube switch has a problem.Solution: contaminate the float regularly. If the magnetism is weakened, you can use a magnetic rod to go back and forth several times to increase the magnetism. When there is a problem with the trunk, you can only use a multimeter to measure the damaged part and then shield it.Cleaning method of magnetic levitation water level gauge3. It may appear if it is telexed. The results of on-site and telex are different. In this case, we must first check whether there is a problem with the float, then see if it is a teletype converter, and finally check our wiring and our system. Solution: Open after pollutants are discharged, check the float, then measure the current signal with a multimeter, confirm that there is no problem with the system and wiring, and finally calibrate it to our converter
Post time: 21-09-21