The maglev of the magnetic flap level gauge is an important part of the level gauge. If the maglev is damaged, sunken, stuck, etc., it will directly affect the normal use of the level gauge. The following editor will introduce the common causes of sinking of the maglev level gauge.
1. What are the requirements for installing a magnetic buoy in a magnetic flap level gauge?1. Magnetic device requirements: In order to avoid the buoy from being damaged by the sliding impact of the maglev during transportation, before leaving the factory, use a magnetic flip plate level gauge to fix the edge of the buoy on the edge of the buoy. Before installation, open the flange, and then put the head of the heavy end, that is, the head up into the buoy, being careful not to turn it upside down.2. Valve installation requirements: a valve should be installed between the magnetic flip plate level gauge and the container to cut off the material at any time during cleaning and maintenance.3. The internal and external environment requirements of the buoy: no magnets are allowed around the cylinder of the magnetic flip plate level gauge, especially the use of iron clamps, otherwise it will affect the normal operation of the level gauge; the medium should not contain solid impurities or magnetic substances, so as not to block the float . According to the condition of the medium, the buoy can be cleaned regularly to eliminate internal impurities.4. Before applying, the correction magnet for sub-zero flakes should be set to red, and the rest should be set to silver white.Magnetic Flip Plate Level Gauge MaglevSecond, what are the applicable places for the magnetic flap level gauges of the high and low alarm water tanks?It is suitable for high temperature, high pressure, strong acid, strong alkali, explosion-proof and other requirements. The structure is simple, reliable and durable. A variety of optional accessories can be added to make it easier to control. Install the liquid level transmitter and magnetic switch, you can install or adjust at any time without stopping the machine. If the power supply is interrupted, the magnetic field switch will not be affected, and the accuracy is high. Add a color chip of different colors every 10 cm to facilitate the identification of the liquid level. Used in dyeing and finishing equipment, wastewater treatment, power plants, chemical equipment, thermal kerosene boilers, petrochemical industries and other industries.Third, what is the cause of the maglev sinking in the magnetic flip plate level gauge?1. The maglev is corroded and leaked. Maglev is an important part of the magnetic disk level gauge. If the maglev is not properly treated, the anti-corrosion effect is not good, and it cannot withstand the corrosion of strong corrosive liquids, the maglev will leak due to corrosion, and the leaked magnetic suspension level will no longer change with the rise and fall of the liquid level, and it will not change. The accurate value may be observed by the magnetic disk level gauge.Magnetic Flip Plate Level Gauge Maglev2. The maglev is stuck. If there are too many impurities in the medium measured by the magnetic reversal plate level gauge, if the maglev is stuck for a long time, or the maglev is attached to too many impurities, causing the maglev density to be too high, there will be sedimentation, which is also a magnetic reversal One of the common failures of the plate level gauge, a good way to solve this problem is to regularly remove the impurities on the maglev and buoy.If the maglev of the magnetic disc level gauge is stuck or sinks, Huitian Instruments recommends that everyone check it carefully. If the situation is serious, the maglev must be replaced in time.
Post time: 21-09-21