Customers will be particularly annoyed when they encounter inaccurate or wrong measurements with the remote magnetic flap level gauge. This phenomenon is either caused by the quality of the product itself or caused by its use. There are many reasons for the troubles. Let us use the data to find out the reasons that often lead to inaccurate measurements for your reference!The reasons for the inaccurate measurement of the magnetic flap level gauge are subdivided into two prominent reasons: the inaccurate display of the red and white flap columns and the deviation of the remote signal output. The following four reasons are the reasons for inaccurate measurement1. The verification process verifies the true value of the liquid level and confirms that there is a liquid level. Or open the diversion device to check if there is a liquid level.2. Check whether the upper shut-off valve is open. If it is confirmed that there is a liquid level check float, open and close the shut-off valve, and make the magnetic flap liquid level gauge run again.3. Use a magnetic rod to sense on the cylinder wall, confirm the position of the float, confirm that the float is not stuck, and then paint the lower part of the float red and the upper part white.4. If the numerical reference of this density is not very accurate, it will actually have a certain influence on its measurement, so if this problem occurs, pay attention to checking the numerical value of this density.
Post time: 21-09-21